D.I.Y. Recycled Crystal Bullet Necklace

51

23
46photo-3

▼▼▼▼

Scattered cartridges are often a symbol of great suffering, casualties, hatred, and war. Crystals, being quite the opposite, have been used for centuries as a tool with extensive healing powers, symbolic in bringing harmony and balance. I intentionally brought these two iconic pieces together to create a wearable dichotomy. In this recycled necklace, natural elements and man-made creations are united, bringing congruity to discrepancy. Depending on the crystal you use, this D.I.Y. is almost free. I gathered discarded bullet shells at a local shooting spot (free), and the most expensive crystal (green tourmaline) was $7. Similar necklaces retail for upwards up $330 here.

Materials:

Bullet Shells
Crystal Points (fitted to each bullet shell)
Dremel Drill w/ 1-2 mm Drill Bit
Round Nose Pliers
Head Pins
Wrench
Thin Cloth
Hot Glue Gun

***Metal File-optional

Directions:

Collect recycled shells, and take them to a mineral store where you can fit each crystal to its respective shell. Make sure it is a tight fit, to where you almost wouldn’t need to glue it (Tip: if there is a rough or fat edge, use a metal file to shape it to your liking). I ended up purchasing, clear quartz, Tibetan quartz, and green tourmaline. There are two methods for attaching a chain 1)Two holes through the top of the shell or 2)One hole through the primer of the bullet, with attached and looped head pin. They both take the same amount of time, so it just depends on how you want it to look/hang on a chain… I did a few of both. Using a cloth to wrap around the shell before clamping with a wrench is important, so you dont scratch the shells in the drilling process. Drill two holes through opposite sides of the top of the shell (shown in picture #1). Drill one hole directly through the top of the primer for looped attachments. For looped attachments; thread head pin through the casing of the bullet up through the hole in the primer. Using round nose pliers, grasp the end of the head pin, and roll down tightening into a circular loop (shown in picture #4). Heat the glue gun. ***For double drilled attachment, make sure to roll a small piece of paper and install through both holes before gluing, this will insure the glue doesnt block where the chain will run through. Have the crystal ready, and dispense a small amount of glue up into the casing (make sure there wont be excess when the crystal is pushed in). Immediately insert crystal, wipe any extra glue. The hot glue not only secures the crystal, but also the loop attachment. Hang on a chain or even charm bracelet of your liking…would also be cool layered with other charms/feathers etc.

Tagged , , , , , , , , , , , , , , , , , , , , , , , , ,

One thought on “D.I.Y. Recycled Crystal Bullet Necklace

  1. Madison says:

    This is really cool Halley! I love this Idea.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: